The 1992 Freightliner MB60 has 5 safety recalls and 0 owner complaints on file with NHTSA.
Recalls5safety recalls
Complaints0filed by owners
Crashes · fires0 · 0reported in complaints
Injuries · deaths0 · 0reported in complaints
Safety recalls
Exterior lighting › Turn signal › Switch
NHTSA recall 97V114001 · Aug 4, 1997 · 77,000 vehicles · opened after NHTSA action (ODI)
Problem: VEHICLE DESCRIPTION: HEAVY DUTY TRUCK. THE SHOULDER BOLT WHICH HOLDS THE GROTE TURN SIGNAL SWITCH CASE AND COMPONENTS TOGETHER CAN LOOSEN RESULTING IN THE TURN SIGNAL MALFUNCTIONING.
Risk: IF THE TURN SIGNAL FUNCTION IS LOST, FOLLOWING MOTORISTS WOULD NOT BE AWARE OF THE TURNING VEHICLE, INCREASING THE RISK OF A VEHICLE CRASH.
Fix: DEALERS WILL INSPECT THESE VEHICLES AND TIGHTEN ANY LOOSE BOLTS AND IN THE TURN SIGNAL SWITCH WITHIN 2 YEARS FROM THE DATE OF THE RECALL NOTIFICATION LETTER. THE SHOULDER BOLT WILL BE REMOVED, CLEANED, AND REINSTALLED WITH LOCTITE. OWNERS CAN ALSO REQUEST LOCTITE AND REPAIR INSTRUCTIONS SO THEY CAN FIX THE VEHICLES THEMSELVES.
Parking brake › Conventional › Mechanical
NHTSA recall 95V094000 · May 9, 1995 · 3,050 vehicles
Problem: THE PARKING BRAKE LEVER MAY NOT TRAVEL FAR ENOUGH OVER CENTER TO ASSURE THAT IT REMAINS IN THE PROPER POSITION ALLOWING THE VEHICLE TO ROLL AWAY WHILE PARKED.
Risk: IF THE VEHICLE IS NOT PROPERLY PARKED WITH THE TRANSMISSION IN THE CORRECT POSITION, AND IF THE VEHICLE IS PARKED ON A GRADE, IT COULD UNINTENTIONALLY ROLL AWAY INCREASING THE POTENTIAL FOR AN ACCIDENT.
Fix: DEALERS WILL REMOVE AND REPLACE THE PARKING BRAKE LEVER WITH A LEVER THAT REQUIRES A 25 LB. EFFORT TO RELEASE.
Service brakes, air › Drum › Chamber
NHTSA recall 95V018000 · Feb 6, 1995 · 5,700 vehicles
Problem: THE BRAKE CHAMBER MOUNTING STUDS CAN LOOSEN OR PULL THROUGH DUE TO FATIGUE IN THE BRAKE CHAMBER HOUSING CAUSED BY FOUNDATION BRAKE CHATTER.
Risk: THIS CONDITION CAN RESULT IN LOSS OF BRAKING CAPABILITY.
Fix: DEALERS WILL CHANGE THE BRAKE LINING MATERIALS, REPLACE THE WING BRACKET WITH A REINFORCED BRACKET AND INSTALL BRAKE CHAMBERS WITH REINFORCED CHAMBER HOUSING AND LARGER (1/2") MOUNTING STUDS.
Visibility › Windshield wiper/washer
NHTSA recall 93V148000 · Sep 14, 1993 · 985 vehicles · opened after NHTSA action (ODI)
Problem: THE WINDSHIELD WIPER ARM SUPPORT CRACKS WHERE THE WIPER ARM PIVOT MOUNTS TO THE SUPPORT BRACKETS CAUSING FAILURE OF THE SYSTEM.
Risk: FAILURE OF THE WINDSHIELD WIPER SYSTEM REDUCES DRIVERVISIBILITY IN INCLEMENT WEATHER WHICH COULD RESULT IN AN ACCIDENT.
Fix: REMOVE AND REPLACE THE WINDSHIELD WIPER ARM SUPPORT BRACKET WITH A REDESIGNED SUPPORT BRACKET.
Problem: A NUMBER OF CABS WERE ASSEMBLED WITH FEWER WELDS THAN SPECIFIED IN THE UPPER B PILLAR NEAR THE ANCHORAGE FOR THE SEAT BELT. WELDING MATERIALS USED ON THE INBOARD ANCHORAGE BRACKET UNDER THE CAB DECK WILL NOT MEET FMVSS NO. 210 LOAD TEST REQUIREMENTS WHEN THREE SEATING POSITIONS ARE PROVIDED.
Risk: SAFETY BELT ANCHORAGE SYSTEMS THAT DO NOT COMPLY TO THELOAD TEST REQUIREMENTS SUBJECT THE SEAT OCCUPANT TO GREATER RISK OF INJURY INTHE EVENT OF A SUDDEN STOP OR ACCIDENT.
Fix: ADD REINFORCEMENT WELDS IN THE UPPER B PILLAR AND ADD FASTENERS TO THE LOWER DECK ANCHORAGE BRACKET.
Recall repairs are free at any authorised dealer. A recall listed here may already have been fixed on a particular car: enter its 17-character VIN at nhtsa.gov/recalls to see open recalls.