1997 BMW R1100 Recalls & Problems

Safety recalls

Electrical systemDec 31, 1997

Wiring

Recall 97V2370002,000 vehiclesopened after NHTSA action (ODI)

Problem: VEHICLE DESCRIPTION: MOTORCYCLES. A SHEET METAL PLATE MOUNTED TO THE FRONT OF THE FRAME BELOW THE INSTRUMENT CLUSTER CAN CAUSE THE WIRING HARNESS TO BE STRETCHED TOO TIGHT AS THE HANDLEBARS ARE TURNED FULLY TO ONE SIDE. IN ADDITION, THE WIRING HARNESS IS ATTACHED TO ANOTHER HARNESS WITH A CABLE TIE THAT IS PLACED TOO FAR FORWARD LIMITING THE HANDLEBAR MOVEMENT.
Risk: THE HARNESS WIRES CAN BE DAMAGED OR COULD BREAK OR PULL OUT OF THE IGNITION SWITCH. IF THE HARNESS WIRES WERE DAMAGED BUT NOT BROKEN OR DISCONNECTED, THE ELECTRICAL SYSTEM COULD BE AFFECTED WHILE THE MOTORCYCLE IS BEING DRIVEN. HESITATION, MISFIRING, OR "CUTTING OUT" COULD OCCUR INCREASING THE RISK OF A VEHICLE CRASH.
Fix: DEALERS WILL RELOCATE THE WIRE TIE CONNECTING THE TWO WIRING HARNESSES TO A POINT FURTHER BACK FROM THE ORIGINAL LOCATION SO THAT THE IGNITION SWITCH WIRING HARNESS HAS SUFFICIENT FREEDOM OF MOVEMENT. ALSO IF THE WIRING HARNESS IS FOUND TO BE DAMAGED, THE IGNITION SWITCH (WITH HARNESS) WILL BE REPLACED.

Recall repairs are free at any authorised dealer. A recall listed here may already have been fixed on a particular car: enter its 17-character VIN at nhtsa.gov/recalls to see open recalls.

NHTSA defect investigations

STEERING LOCK/IGNITION SWITCH WIRINGClosed

BMW WILL CONDUCT A SAFETY RECALL TO REMOVE THE SHEET METAL PLATE AND RELOCATE TWO WIRING HARNESSES SO THAT THE IGNITION WIRING HARNESS HAS SUFFICIENT FREEDOM OF MOVEMENT THROUGHOUT THE RANGE OF MOTION OF THE HANDLEBARS.WIRING HARNESSES FOUND DAMAGED, WILL BE REPLACED.NO FURTHER ACTION IS NECESSARY.THIS INVESTIGATION IS CLOSED.

SQ97022 · opened Nov 14, 1997 · closed Dec 31, 1997

Safety recalls

Wiring

NHTSA defect investigations