Loss of headlightsClosedLed to recall 15V861000
The Office of Defects Investigation (ODI) opened an investigation concerning the loss of headlights in model year (MY) 2003-2005 Ford Crown Victoria and Mercury Grand Marquis vehicles. The subject vehicles share the same architecture and major components.ODI has received 636 unique reports (for all submission dates) related to the alleged defect, with owners describing a loss of both low and/or high beam headlights occurring while driving.ODI identified 4 Vehicle Owner Questionnaire ( VOQ) reports alleging minor crash or loss of control incidents due to headlight failures.Drivers alleged running off of the road due to a lack of headlights and one driver reportedly struck a deer.No injuries were indicated in the VOQ crashes.In response to ODI's Information Request (IR) letter, Ford Motor Company (Ford) responded with 4173 unique reports related to the alleged problem.There were a total…
PE15028 · opened Aug 10, 2015 · closed Jan 8, 2016Loss of headlamp/exterior lightingClosed
In a letter dated October 2, 2014 the Office of Defects Investigation (ODI) was initially petitioned by the North Carolina Consumers Council, Inc. requesting a defect investigation of an alleged defect condition resulting in headlight and/or exterior lighting failure on 2003-2005 Ford Crown Victoria and Mercury Grand Marquis vehicles.ODI analyzed Vehicle Owner Questionnaire (VOQ) complaints received from consumers and identified a total of 605 reports (for all submission dates) alleging headlight failure.The complaints indicate failures of both low beam headlights typically while driving, a defect condition that was evaluated under a prior ODI investigation (PE08066).Most consumer VOQs indicate that the headlights failed suddenly and without warning leaving the driver with no forward lighting, however some report the headlights flickered or dimmed prior to turning off.In some cases…
DP15002 · opened Apr 1, 2015 · closed Aug 11, 2015Steering Column Shaft ObstructionClosed
On July 7, 2014 the Office of Defects Investigation (ODI) opened a preliminary evaluation based on five complaints (VOQs) alleging incidents ofinterference between dislodged exhaust manifold heat shields and the lower steering shaft/knuckle, including one alleging the interference resulted in a crash on a highway entrance ramp. Since opening this investigation, ODI has received four additional owner complaints.One indicated that the shield was removed before binding could occur.The other three occurred at low speed and produced some momentary steering binding that was overcome by the driver when additional steering effort was applied.Once the shield was repaired or removed, the steering returned to normal.The single incident ODI identified as a possible crash (VOQ No. 10578715) related to this condition could not be verified and the description of the crash in the complaint was not…
PE14021 · opened Jul 7, 2014 · closed Nov 21, 2014Loss of Steering ControlClosedLed to recall 13V385000
In its recall notice dated August 26, 2013, Ford Motor Company (Ford) notified NHTSA of a safety defect condition that may result in loss of steering in approximately 355,000 model year (MY) 2005 through 2011 Ford Crown Victoria and Mercury Grand Marquis vehicles built at the St. Thomas Assembly Plant, MY 2005 through 2007 Lincoln Town Car vehicles built at the Wixom Assembly Plant, and certain MY 2008 through 2011 Lincoln Town Car vehicles built at the St. Thomas Assembly Plant and that are currently registered or were originally sold in Connecticut, Delaware, the District of Columbia, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, West Virginia, or Wisconsin (NHTSA Recall 13V-385, Ford Recall 13S08).Ford's recall addresses a corrosion related…
EA13004 · opened Apr 26, 2013 · closed Nov 15, 2013Loss of Steering ControlClosed
In the subject vehicles, the mechanical connection between the steering wheel and rack and pinion steering assembly consist of the steering column and an upper and lower intermediate shaft.A disconnection of any of these components from the steering system can create a loss of steering control.Allegations of a loss of steering control incidents reviewed during the Preliminary Evaluation PE12-025 appear to be related to a separation of the upper and lower shafts within the steering the column. In response to the Office of Defects Investigation's (ODI) Information Request (IR) during PE12-025, Ford provided 2 complaints and 9 warranty claims related to the alleged defect in the subject vehicles (see Figure 1 for an exemplar picture).ODI has received 5 complaints related to the alleged defect, including 1 related to an incident reported in one of the Ford complaints.The incident rate…
PE12025 · opened Sep 14, 2012 · closed Apr 26, 2013LOSS OF HEADLIGHT FUNCTIONClosed
THE AGENCY HAS CLOSED THIS INVESTIGATION BASED ON ITS REVIEW OF COMPLAINT REPORTS, FIELD AND TECHNICAL DATA PROVIDED BY FORD AND COMPLAINANT INTERVIEWS. FORD FOUND THAT SOME LIGHTING CONTROL MODULES (LCM) IN THE SUBJECT VEHICLES CONTAINED DEFECTIVE SOLDER JOINTS ON THE PRINTED CIRCUIT BOARD.THIS CONDITION CAN LEAD TO POOR HEADLIGHT PERFORMANCE RANGING FROM INTERMITTENT OUTAGE AND DIMMING TO EVENTUAL HEADLIGHTS FAILURE.THE FAILURE DOES NOT AFFECT OTHER LIGHTING FUNCTIONS (PARK, EMERGENCY FLASHER, BRAKE AND FLASH TO PASS LIGHTS).THE AGENCY IS AWARE OF A TOTAL OF 306 CONSUMERS COMPLAINTS AND NO REPORT OF CRASH, INJURY OR FATALITY.FORD REPORTS 2,074 WARRANTY CLAIMS RELATED TO HEADLIGHT FAILURE LINKED TO THE LCM DURING THE FIRST THREE YEARS OF OPERATION.ABOUT 12% (247) OF THESE CLAIMS ARE SPECIFIC TO HEADLIGHT FAILURE WHILE DRIVING.THE AVERAGE WARRANTY RATE FOR HEADLIGHT FAILING WHILE…
PE08066 · opened Nov 26, 2008 · closed Mar 24, 2009FRACTURE OF THE STEEL WHEEL RIMClosed
DURING A SEPTEMBER 23, 2004 MEETING AND IN SUBSEQUENT DISCUSSIONS IN NOVEMBER, FORD ADVISED THE OFFICE OF DEFECTS INVESTIGATION (ODI) OF THEIR PLANS TO INTRODUCE AN IMPROVED STEEL WHEEL FOR MANUFACTURING AND SERVICE COMPONENT USE ON THE SUBJECT VEHICLES, INDICATING THIS WOULD OCCUR IN DECEMBER 2004.THE NEW WHEEL DESIGN INCORPORATES AN ADDITIONAL MANUFACTURING PROCESS (SHOT PEENING) WHICH LOWERS TENSILE STRESS IN THE SURFACE LAYER OF THE RIM MATERIAL ADJACENT TO THE CIRCUMFERENTIAL WELD. THEORETICALLY THIS SHOULD IMPROVE RIM DURABILITY BY REDUCING FATIGUE CRACK INITIATION SITES.INDICATIONS FROM FORD?S ACCELERATED TESTING METHODS SHOW AN IMPROVEMENT IN THE PERFORMANCE OF THE NEW WHEEL.IN ADDITION TO PRIOR SAFETY RECALL 03V279 AND SERVICE ACTION (SA) 03M03, FORD WILL ANNOUNCE A NEW EXTENDED WARRANTY SA FOR VEHICLES BUILT PRIOR TO DECEMBER 2004 THAT SUFFER RIM FRACTURES IN SERVICE.THE NEW…
RQ04007 · opened Aug 2, 2004 · closed Dec 20, 2004