Model year record
2004 Porsche 911 recalls & problems
The 2004 Porsche 911 has no safety recalls on file with NHTSA, and 8 owner complaints. The most-reported problem area is engine (6 complaints).
Safety recalls
No safety recalls have been filed for the 2004 Porsche 911.
Recall repairs are free at any authorised dealer. A recall listed here may already have been fixed on a particular car: enter its 17-character VIN at nhtsa.gov/recalls to see open recalls.
What owners report
| Problem area | Complaints | Typical mileage* |
|---|---|---|
| Engine | 6 | 17,042 mi |
| Engine and engine coolingEngine | 2 | — |
| StructureBody | 1 | — |
| Power train | 1 | — |
*Median odometer reading when the problem happened, where owners gave one. One complaint can name several problem areas.
Recent owner complaints
- Engine
Yesterday as I was driving in freeway, my friend was following me from behind, he noticed smoke and coolant leaking making his car's windshield dirty. So we stopped at gas station and noticed good amount of coolant leakage from underneath which make the back of the car and tires big mess. I noticed, before my friend's call, the handling and grip of the car was little off, I didn't know why but then I realized leaking made the tires slippery. Tow the car to my house and just wanted to report this. It seems lot of people complain about this issue when I started reading about it last night.
- Engine
THE M96 MOTOR SUPPLIED WITH THIS VEHICLE LINE HAS HAD THE FOLLOWING PROBLEMS. ENGINE BLOCK LEAKS THE BLOCK IS POROUS. RESLEEVED CYLINDERS WERE MAKER FIX ,THE SLEEVES MOVED CAUSING ENGINE DESTRUCTION. A MAIN CRANKSHAFT BEARING WAS DESIGNED OUT. ALLOWING THE CRANKSHAFT TO MOVE FRT TO BACK AND WITH GRAVITY CAUSING A FAILURE OF THE REAR MAIN SEAL COULD NOT FIX IF CRANK HAD MOVED MORE THAN A FEW DEGREES FROM ORIG SPEC.PRIMARY PROBLEM IMS( INTERMEDIATE SHAFT) FAILURE. RESULT, COMPLETE DESTRUCTION OF MOTOR. NO FIX FROM MANUFACTURE. AFTER MARKET ONLY SUPPLY. OVER TEN THOUSAND AFTER MARKET REPAIRS DONE.CONSERVATIVE APX COST $,3000 I HAVE MUCH MORE EVIDENCE. *TR
- Engine
MY GT3 HAS COOLING PIPE ON THE ENGINE EXTERNAL TO THE BLOCK. I HAVE READ THIS IS A SYSTEMIC ISSUE WITH THE ENGINE USED IN GT3 AND TURBOS (METZGER MOTOR). A FITTING COMES LOOSE DUE TO ADHESIVE FAILURE RESULTING I LOSS OF ALL OR MOST OF THE COOLANT FLUID. THE REPAIR REQUIRES ENGINE REMOVAL AND REPAIR OF THE FITTINGS. THERE IS SOME ISSUE AS TO THE PROPER OR BEST REPAIR APPROACH. WHAT IS KNOW IS THAT THE ADHESIVE FAILURE IS ALMOST SURE TO OCCUR. I HAVE BEEN LUCKY AS I HAVE FEW MILES ON MY VEHICLE AND HAVE NOT YET EXPERIENCED THIS FAILURE, BUT VERY CONCERNED THIS WILL OCCUR AND THE SUDDEN LOSS OF COOLANT FLUID WILL MOST LIKE RESULT IN A SPINOUT OR CRASH. EVEN IF NO ACCIDENT WERE TO RESULT, I AM…
- Structure › BodyCrash1 injury
THE EVENT HAPPENED IN 2008. PURCHASED PORSCHE GT 3 FROM PORSCHE DEALER IN 2006. ACCELERATING ONTO A LIMITED ACCESS HIGHWAY FROM AN ENTRANCE RAMP THE CAR MADE A VIOLENT FISHTAIL MOVEMENT IN A COUNTERCLOCWISE DIRECTION CAUSING A 180 DEG. SPIN. I TRIED TO CORRECT BUT NO RESPONSE AND THEN APPLIED BRAKES HEAVILY BUT CAR CONTINUED ITS MOVEMENT EVENTUALLY HITTING A CONCRETE BARRIER IN THE RIGHT REAR. THE CAR HAD TO BE TOWED AND EVENTUALLY TOTALED BY THE INSURANCE COMPANY. AT THE IMPACT SITE I DID NOTICE FLUID ON THE ROAD AND ALSO BACK UP THE ROAD. SINCE MY WIFE WAS INJURED AND NEEDED TO BE TAKEN TO THE HOSPITAL, I WAS MORE FOCUSED ON TENDING TO HER BUT AS I LOOK BACK AND ALSO READING ABOUT THE…
- Engine
THE ABOVE CAR HAS A FACTORY WATER COOLING SYSTEM THAT INVOLVES ALUMINUM PIPING THAT IS EPOXIED INTO THE BLOCK AFTER APPROXIMATELY 24 MONTHS OF USE THE EPOXY FAILS AND ALL THE COOLANT IS EVACUATED FROM THE SYSTEM ALL OVER THE ENGINE AND THE GROUND THE MOTOR COULD SEIZE AND THE COOLANT ON THE ROAD IN THAT VOLUME CREATES A DANGEROUS SITUATION FOR OTHER DRIVERS.THE EPOXY FIX OFFERED BY PORSCHE FAILED 3 TIMES FOR ME (TWICE MORE SUBSEQUENTLY)UNTIL I HAD A SHOP WELD THE ALUMINUM PIPES TO THE BLOCK. *TR ## VIN FAILED ##
- Engine
THE COOLANT LINES ARE GLUED IN BY FACTORY TO SAVE COSTS. HOWEVER THE GLUE IS FAILING AND THE COOLANT LINES POP OUT AND ANTI FREEZE IS DUMPED EVERYWHERE CAUSING AN UNSAFE CONDITION . PORSCHE IS AWARE OF THEIR PROBLEM BUT DOING MOTHING ABOUT RECALLING OLDER CARS TO BE REPAIRED. I PAID TO REPAIR MY CAR INDEPENDENTLY BUT PORSCHE OWNERS ARE BEING ENCOURAGED TO REPORT THIS SAFERY ISSUE. *TR
- Engine and engine cooling
TRAVELING AT A SPEED OF 30 MILES PER HOUR AT A LOW RPM, I HEARD A LOUD GRINDING NOISE UNDERNEATH THE CAR. INITIALLY I THOUGHT ROAD DEBRIS WAS CAUGHT UNDERNEATH THE CAR AND I WAS DRAGGING IT ALONG WHILE DRIVING. I QUICKLY TURNED THE CAR TO THE RIGHT OFF THE ROAD AND TURNED THE MOTOR OFF. UNDERNEATH THE VEHICLE I NOTICED ALL OF THE ENGINE'S OIL SPEWING OUT FROM THE BOTTOM OF THE ENGINE. I CONTACTED MY INSURANCE COMPANY AND ARRANGED FOR A TOW VEHICLE. I THOUGHT AN OBJECT STRUCK THE UNDERCARRIAGE OF MY CAR. THE CAR WAS INSPECTED BY MY INSURANCE COMPANY AND DETERMINED TO BE A COMPLETE ENGINE FAILURE. NO EVIDENCE OF A ROAD HAZARD PERFORATING THE ENGINE WAS SEEN. SINCE I FILED THIS LETTER I HAVE…
- Engine and engine cooling › Engine
DRIVING ON FREEWAY WHEN HEARD A WEIRD NOISE FROM THE BACK OF THE CAR AND A MESSAGE IN RED CAME UP ON THE INSTRUMENT CLUSTER, LOST POWER TO ENGINE, PULLED OVER AND OIL LEAKING FROM ENGINE. ENGINE COMPLETELY DESTROYED DUE TO IMS FAILURE. ENGINE WAS REPLACED WITH RE-MANUFACTURED ENGINE BY DEALER. *KB
Owner complaints are submitted to NHTSA by the public and are not verified. Shown as filed (NHTSA removes personal details); long reports are shortened.
NHTSA defect investigations
- Rapid coolant lossClosed
On April 26, 2013, the Office of Defects Investigation (ODI) opened PE13-009 to investigate 10 complaints alleging incidents of sudden coolant loss while traveling on public roadways in certain model year (MY) 2001 through 2007 Porsche 911 vehicles.The complaints alleged that pipe ends joined by epoxy to certain cooling system components may fail suddenly and separate, resulting in large volumes of coolant leakage.The investigation was opened to assess evidence of a design or manufacturing defect in the coolant pipe fittings and any related safety consequences. In response to ODI?s Information Request letter, Porsche identified a manufacturing quality issue with the supplier?s application of adhesive to coolant pipe fittings that resulted in elevated failure rates in approximately 6,800 early production 997 generation vehicles (MY 2007 and early MY 2008).ODI?s analysis of field data…